The assembly video series continues…. we now install the Printrboard electronics PCB within the inside of the base assembly of the Printrbot Plus. We also attach the Z-Axis linear bearing rods to the top of the base assembly (perpendicular to the deck plate). This effectively completes everything we are going to do with the base until later. After this step, we will work on some other sub-assemblies before eventually combining our various components into a completed 3D printer. This is a shorter and simpler step relative to some of the prior (and subsequent) assembly steps involved. Still, we take the time to cover the various pitfalls and problems that CAN occur and attempt to show both the mistakes I made along the way and options to overcome these.

source

Four Tricks to Finding a Low-volume PCB Assembly Manufacturer

pcb board assemblies

Working with low-quantity PCB assemblies has its upsides and downsides. As the consumer, there are several pointers that will allow you to make the most from your assembly. Here, we will show you how to maximize the possible benefits and ways to move around the negative aspects.

How you can Pick a Low-volume PCB Assembly Manufacturer?

The guidelines mentioned here should help you maximum benefit from your low-quantity PCB assembly order.


1. A Single Supplier

Find a low-quantity PCB maker who can be a one-stop supplier for all of your PCB demands. The good thing about working with a small order is that you don’t have to coordinate with a couple of organizations or individuals. Your order can be handled by a single point of contact.


2. Value of Prototypes

Even if working with small orders, you must require using prototypes – even though it comes at an further expense. Prototypes will permit you to inspect your design and enhance it, if required.


3. Low-volume PCB Manufacturer

pcb board assemblies

Making low-quantity PCB assemblies could be a task when employing an inexperienced maker. Since the order quantity is low, expense of production will likely be slightly higher. Thereby, any error by the PCB maker will end up in increased losses for the consumer.


4. Standard PCB Practices

Standard best practices involving PCB producing must be taken despite the fact that working with a low-quantity PCB assembly. This consists of design, manufacturing, assy, as well as PCBA testing steps.

Working with a low-quantity PCB assembly has its own list of gains. With standard tips enables you to build an order that will help you in the long run.