The X3 is a production in-line automated x-ray inspection system for up to 100% inspection of solder joints on both single and double-sided printed circuit assemblies. Utilizing both transmission and off-axis imaging, the system can be setup flexibly depending on the SMT process to inspect Side A then Side B, or the Double-sided assembly. While transmission imaging offers the fastest and highest resolution imaging process, the X3 also uses two reconstruction techniques to address double sided assemblies and overlapping solder joints. These include the patent pending Slice Filter Technique and 3D-SART which allows inspection at multiple horizontal cross-sections or “slices”. The X3 can identify Head-in-Pillow (HIP) defects, inspect Package on Package (POP) components and measure / check barrel fill on Thru Hole and Pin-In-Paste processes. The X-3 can also accommodate a front end Automated Optical Inspection Scanner to check for components presence/absence, polarity, off-position, tombstoning, and correct part.

source

4 Guidelines to Deciding on a Small-volume PCB Assembly Manufacturer

pcb board assembly

Working with low-quantity PCB assemblies has its advantages and drawbacks. As the purchaser, there are some pointers that can help you obtain the most out of your assembly. In this posting, we will let you know how to benefit from the pros and the ways to keep away from the negatives.

Methods to Choose a Small-volume PCB Assembly Manufacturer?

The guidelines pointed out here should help you obtain the most from your low-quantity PCB assembly order.


1. One Supplier

Choose a low-quantity PCB fabricator who can be a one-stop service provider for all your PCB demands. The advantage of working with a small order is that you don’t need to coordinate with various organizations or individuals. Your order can be handled by a single point of contact.


2. Worth of Prototypes

Even if working with small orders, you must require use of prototypes – though it comes at an increased expenditure. Prototypes enables you to check your design and enhance it, when necessary.


3. Small-volume PCB Manufacturer

pcb board assembly

Fabricating low-quantity PCB assemblies can be a task when working together with an inexperienced fabricator. Since the order quantity is low, cost of production will likely be slightly higher. Subsequently, any error from the PCB fabricator will trigger bigger losses for the purchaser.


4. Standard PCB Practices

Standard tips relating to PCB making needs to be implemented even if working with a low-quantity PCB assembly. This consists of design, fabricating, assemblage, and additionally PCBA testing procedures.

Working with a low-quantity PCB assembly has its own couple of perks. With the help of standard tips will permit you to build an order that may help you over time.