This is an example of a PCB automated programming and functional test equipment. It was developed and assembled by Melitech Design Ltd for a client. This system can test 7 different pcbs just by changing the cassette with bed of nails. The rest is common for all boards. The system was built using the following components which are available from our stock.:

PCB Test Adaptor
Cassette for Bed of nails
Controller Card
Relay expansion board
LCD Module

These can be bought as components to build your own system or we can design, machine and build the system for you according to your pcb testing requirements.

Feel free to contact us for further information on


or visit our website



Four Suggestions for Choosing a Low-volume PCB Assembly Producer

pwb assembly

Working with small-quantity PCB assemblies has its benefits and drawbacks. As the buyer, there are several pointers that will let you get the most out of your assembly. In this posting, we’re going to let you know how to utilize the benefits and the ways to get around the problems.

Methods to Pick out a Low-volume PCB Assembly Producer?

The information referred to just below should help you make the most from your small-quantity PCB assembly order.

1. One Supplier

Decide on a small-quantity PCB fabricator who can be a one-stop provider for all your PCB needs. The main benefit of working with a small order is basically that you don’t need to coordinate with a couple of organizations or individuals. Your order can be handled by a single point of contact.

2. Incredible importance of Prototypes

Even if working with small orders, you must insist upon use of prototypes – regardless if it brings about an additional expense. Prototypes will permit you to inspect your design and improve on it, when required.

3. Low-volume PCB Producer

pwb assembly

Manufacturing small-quantity PCB assemblies can be a task when working with an unsophisticated fabricator. Since the order quantity is low, expense of production will be a little higher. So, any mistake from the PCB fabricator will be responsible for larger losses for the consumer.

4. Standard PCB Practices

Standard suggestions involving PCB producing needs to be followed even when working with a small-quantity PCB assembly. This consists of design, manufacturing, assemblage, and even PCBA testing procedures.

Working with a small-quantity PCB assembly has its own variety of positive factors. With the help of standard best practices will help you to build an order that might help you over the long haul.