Applicable PCB (L x W): 50 × 50 to 700 × 460mm
Minimum component: 0201
Minimum QFP pitch: 0.4mm
Minimum IC pitch: 0.30mm
Minimum BGA ball diameter: 0.40mm
Ball pitch: 1.0mm
Maximum BGA size: 74x74mm

source

4 Rules to Selecting a Small-run PCB Assembly Manufacturer

pc board assembly

Working with low-quantity PCB assemblies has its advantages and cons. As the buyer, there are some helpful tips that will allow you to make the most from your assembly. On this page, we will let you know how to make the most of the positives and the ways to get around the potential problems.

The way to Decide on a Small-run PCB Assembly Manufacturer?

The tips referred to down the page should help you maximum benefit from your low-quantity PCB assembly order.


1. Single Service Provider

Decide on a low-quantity PCB producer who can be a one-stop service provider for all of your PCB demands. The benefit of working with a small order is basically you don’t have to coordinate with several organizations or individuals. Your order can be treated by a single point of contact.


2. Worth of Prototypes

Even if working with small orders, you must insist on use of prototypes – regardless if it comes at an added expenditure. Prototypes will assist you to verify your design and fine-tune it, if required.


3. Small-run PCB Manufacturer

pc board assembly

Producing low-quantity PCB assemblies can be a task when using an low compertition producer. For the reason that order quantity is low, cost of production will probably be a little higher. So, any error on the part of the PCB producer will bring on increased losses for the consumer.


4. Standard PCB Practices

Standard recommendations concerning PCB manufacturing really should be taken even when working with a low-quantity PCB assembly. This consists of design, fabricating, assembly, as well as PCBA testing processes.

Working with a low-quantity PCB assembly has its own variety of positive factors. Utilising standard tips enables you to build an order that can help you in time.