ALBATRON’s conformal coat will protect an active, working circuit board as it is submerged water.


Four Tactics to Deciding on a Low-volume PCB Assembly Producer

pcb board assembly

Working with small-run PCB assemblies has its benefits and downsides. As the client, there are a few suggestions that can help you get the most out of your assembly. In the following paragraphs, we shall let you know how to make the most of the good things and the ways to keep away from the negative aspects.

Find out how to Go with a Low-volume PCB Assembly Producer?

The ideas talked about in this article should help you maximum benefit from your small-run PCB assembly order.

1. One Supplier

Pick out a small-run PCB maker who could be a one-stop service provider for all your PCB demands. The advantage of working with a small order is basically that you don’t need to coordinate with various organizations or individuals. Your order can be handled by a single point of contact.

2. Great need of Prototypes

Even if working with small orders, you must require use of prototypes – despite that it comes at an added cost. Prototypes will let you check your design and enhance it, if necessary.

3. Low-volume PCB Producer

pcb board assembly

Fabricating small-run PCB assemblies can be a task when employing an not experienced maker. Since the order quantity is low, expense of production is going to be marginally higher. For this reason, any mistake on the part of the PCB maker will cause increased losses for the customer.

4. Standard PCB Practices

Standard tips relating to PCB producing must be followed even if working with a small-run PCB assembly. This includes design, manufacturing, assembly, and even PCBA testing processes.

Working with a small-run PCB assembly has its own group of plus points. Utilizing standard guidelines will help you to build an order that might help you down the road.